Agilent 1100 Series HPLC System

Description

Agilent 1100 Series HPLC System

This item comes with a 30-day Repair or Replace warranty.   

This HPLC system is in very good condition. All operational testing was completed successfully, and each unit functions as intended. We used in-house software for testing. Please Note: If you need computer and software, please contact us for information prior to ordering, otherwise will come only with what is shown.

G1329A – Autosampler 

• Injection Range: 0.1 to 100 µL 
• Injection Precision: < 0.5% RSD 
• Sample Capacity: 100 × 2 mL vials or 2 × 96 well plates 
• Carryover: < 0.05% 
• Injection Cycle Time: 15 seconds 
• Temperature Control: Optional, 4-40°C 
• Dimensions (DxWxH) : 13.6 x 17.1 x 7.1 in 
• Weight: 24 lbs. 

G1330B – Autosampler Thermostat 

• Operating Temperature Range: 4 to 40°C (39 to 104°F) 
• Operating Humidity Range: < 95%, non-condensing 
• Maximum Power Consumption: 260 VA (210 W) 
• BTU: 717

G1316A – TCC 

• Temperature Range: 10°C below ambient to 80°C 
• Temperature Stability: ± 0.15°C 
• Temperature Accuracy: ± 0.8°C 
• Column Capacity: Three 30 cm columns 
• Warm-up/Cool Down Time: 5 minutes from ambient to 40°C 

G1315B – DAD 

• Detection Type: 1024-element photodiode array 
• Light Source: Deuterium and tungsten lamps 
• Wavelength Range: 190 – 950 nm 
• Short Term Noise: ± 1 x 10^-5 AU at 254 and 750 nm 
• Drift: 2 x 10^-3 AU/hr at 254 nm 
• Linear Absorbance Range: > 2 AU (upper limit) 
• Wavelength Accuracy: ± 1 nm 
• Slit Width: Programmable slit widths of 1, 2, 4, 8, and 16 nm 
• Flow Cells: Various options including standard, semi-micro, micro, high pressure, and nano flow cells 
• Control and Data Evaluation: Agilent ChemStation for LC 
• Analog Outputs: Recorder/integrator: 100 mV or 1 V, output range 0.001 – 2 AU, two outputs 
• Communications: Controller-area network (CAN), GPIB, RS-232C, APG Remote, LAN optional 
• Safety and Maintenance: Extensive diagnostics, error detection, leak detection, and safe leak handling 
• Power Requirements: 100 – 240 VAC, 50 or 60 Hz, 300 VA / 125 W / 427 BTU

G1311A – Quaternary Pump 

• Power: 100 – 240 VAC, ± 10% ~ 50/60Hz ~ 180VA ~ 55W ~ 188BTU 
• Ambient Operating Temp: 4–55 °C (41–131 °F) 
• Ambient Non-Operating Temp: -40–70 °C (-4–158 °F) 
• Humidity: < 95%, at 25–40 °C (77–104 °F), non-condensing 
• Operating Altitude: Up to 2000 m (6500 ft) 
• Hydraulic System: Dual plunger in series pump with proprietary servo-controlled variable stroke drive, floating plungers, and active inlet valve 
• Settable Flow Range: 0.001 – 10 ml/min, in 0.001 ml/min increments 
• Flow Precision: ≤ 0.07% RSD, or ≤ 0.02 min SD, whichever is greater, based on retention time at constant room temperature 
• Flow Accuracy: ± 1% or 10 μl/min, whichever is greater 
• Pressure Operating Range: 0 – 40 MPa (0 – 400 bar, 0 – 5880 psi) up to 5 ml/min; 0 – 20 MPa (0 – 200 bar, 0 – 2950 psi) up to 10 ml/min 
• Pressure Pulsation: < 2 % amplitude (typically < 1 %), at 1 ml/min isopropanol, at all pressures > 1 MPa (10 bar) 
• Compressibility Compensation: User-selectable, based on mobile phase compressibility 
• Recommended pH Range: 1.0 – 12.5, solvents with pH < 2.3 should not contain acids which attack stainless steel 
• Gradient Formation: Low pressure quaternary mixing/gradient capability using proprietary high-speed proportioning valve 
• Delay Volume: 800 – 1100 μl, dependent on back pressure 
• Composition Range: 0 – 95 % or 5 – 100 %, user selectable 
• Composition Precision: < 0.2 % RSD, at 0.2 and 1 ml/min 
• Communications: Controller-area network (CAN), GPIB, RS-232C, APG Remote: ready, start, stop and shut-down signals, LAN optional 

G1322A – Vacuum Degasser 

• Channels: 4-channel vacuum container 
• Components: Includes 4 tubular plastic membranes and a vacuum pump 
• Function: The vacuum pump generates a partial vacuum in the vacuum container, which is measured by a pressure sensor  

Ebay

Contact Us